Chimney Lining

July 3, 2017

Replaced Breeching

July 3, 2017

Chimney Lining

Published by EMGIndustrialChimney at July 3, 2017

Tags

: 2 Setting up Scaffold, Tools and Staging Pipe for Chimney Lining Installtion

: 2 Setting up Scaffold, Tools and Staging Pipe for Chimney Lining Installtion

: 2 Setting up Scaffold, Tools and Staging Pipe for Chimney Lining Installtion

: 3 Removing the exisiting chimney lining so we could install proper sized 10gage welded chimney pipe

: 3 Removing the exisiting chimney lining so we could install proper sized 10gage welded chimney pipe

: 3 Removing the exisiting chimney lining so we could install proper sized 10gage welded chimney pipe

: 3 Removing the exisiting chimney lining so we could install proper sized 10gage welded chimney pipe

: 3 Removing the exisiting chimney lining so we could install proper sized 10gage welded chimney pipe

: 3a Laying down new concrete pad at base of chimney for lining support

: 3a Laying down new concrete pad at base of chimney for lining support

: 3a Laying down new concrete pad at base of chimney for lining support

: 3a We fabricated and installed new clean out access for base of chimney

: 4 Installing Custom Fabricated Bullet Pipe

: 4 Installing Custom Fabricated Bullet Pipe

: 4 Installing Custom Fabricated Bullet Pipe

: 4a Installing Chimney Pipe From Roof

: 4a Installing Chimney Pipe From Roof

: 4a Installing Chimney Pipe From Roof

: 4a Installing Chimney Pipe From Roof

: 5 After photo of top of chimney with custom chase cover

: 5 After Picture of top of chimney

: 5 After Picture of Top of Chimney with Custom Chase Cover

: 5 After Picture of top of chimney

: 5 New Breeching in Hallway

: 7 Boiler room cleaned and cleared and offsite

: 7 Hallyway cleaned and cleared and off site

: 7 Roof cleaned and cleared and offsite

Chimney Lining
West 238th St Bronx NY 10463

This client needed to get their chimney up to code for a boiler upgrade/conversion so requested an inspection. The chimney was clay and had cracks throughout.

We recommended relining the chimney using 10gage stainless steel. We had to remove the existing clay tiles in the chimney to fit the proper sized 10gage lining.

We obtained the plans and permit for the chimney installation.

For the project we erected scaffold on the roof for access to the top of the chimney for the duration of the project. We installed over 100’ of round ASTM listed butt seam welded 10gage stainless steel pipe.

We installed a base plate on which to land the chimney. At the base of the chimney we installed a gas tight clean out as required by the NYC DOB.

We connected this newly installed chimney lining to the existing breeching using a custom fabricated tee fitting.

At the top of the chimney we installed a custom fabricated chase cover with a cut out and 6” wrap to secure the chimney lining in place.

Once the lining was installed we performed a pressurized smoke test and issued the chimney affidavit for NYC DOB and Con-Edison.