This client needed their boiler chimney brought up to code for a boiler upgrade/conversion.
We obtained the proper plans and permits.
We installed 192 feet of
This client needed to get their chimney up to code so requested an inspection. The chimney was brick lined and had cracks throughout.
We recommended relining the chimney using 10gage stainless steel.We obtained the plans and permit for the chimney installation.
For the project we erected scaffold on the roof for access to the top of the chimney for the duration of the project. We installed over 190’ of rectangle ASTM listed butt seam welded 10gage stainless steel pipe.
We installed a base plate on which to land the chimney. At the base of the chimney we installed a gas tight clean out as required by the NYC DOB.
We connected this newly installed chimney lining to the existing breeching using a custom fabricated tee fitting.
At the top of the chimney we installed a custom fabricated chase cover with a cut out and 6” wrap to secure the chimney lining in place.
The pipe terminated 3 feet past the top of the masonry chimney outlet.
Once the lining was installed we performed a pressurized smoke test and issued the chimney affidavit for NYC DOB and Con-Edison.